Carefully follow the heating and usage instructions on the leaflet included in the product box.

When the temperature of the wax is correct, it will have an ideal thick and creamy honey texture. Application and removal of the wax will then be as easy as that:

1. Take a generous amount of wax with the end of the spatula.
2. Immediately, with the edge of the spatula, slide the wax in the direction of hair growth, forming a very thin strip of wax.
3. Let the strip dry until it no longer sticks to the touch. With one hand, tighten the skin at the base of the strip and with the other hand, lift the end of the wax with your fingertips using Once waxed, apply a post-waxing wipe.

SI TE SOBRA CERA EN EL TARRO, GUARDA EL FOLLETO PARA LA SIGUIENTE APLICACIÓN.

1. 1. To apply the wax, check the temperature of the wax and the direction of hair growth. Apply a strip of wax approximately 20 cm long with the roll-on in the direction of hair growth. On large areas (legs), two strips of wax can be applied side by side and removed at the same time with the same strip. The width of the strips makes it possible to make better use of them. Before and during epilation, always keep the roban on the waxing tray in the indicated position.
      
   2. To apply the strip, immediately apply the strip by smoothing it firmly in the direction of the hair. Leave one end of the strip free of wax so that you can pull it off more easily. The strips can be used 4 or 5 times in the same epilation and can be washed to be reused in subsequent epilations.
   3. To remove the band immediately, keeping the skin taut, remove the band with a firm, quick movement, flush against the skin and against the grain.

1. Gently melt the wax over a low heat, in a bain-marie or in your melter. The wax is ready when it reaches the consistency of honey. Check that the temperature is right before applying to avoid burns.
2. When it is ready, use the spatula to spread the wax in the direction of the hair, leaving a layer thick enough to cover it.
3. When it has lost its adherence to the touch, without hardening excessively, lift one end and with a strong pull against the grain and against the hair, you will achieve a perfect depilation.
   

1. Gently melt the wax over low heat, in a bain-marie or in your melter. The wax is ready when it reaches the consistency of honey. Before applying the wax, check that the temperature is suitable to avoid burns.
2. When it is ready, use the spatula to spread the wax in the direction of the hair, leaving a layer thick enough to cover it.
3. When it has lost its adherence to the touch, without hardening excessively, lift one end and with a strong pull against the grain and against the hair, you will achieve a perfect depilation.

1. Apply the cream evenly with the applicator, covering the hair.
2. After 5 minutes, remove some of the cream with the spatula. If the skin is still not smooth, leave the cream on for a few more minutes, but never more than 10 minutes.
3. Remove the cream with the help of the spatula, without rubbing, and rinse with cold or lukewarm water.

1. Cleanse the skin, applying a pre-waxing wipe.
2. Wax with the strips:
   1. Hold the strips between your hands for a few seconds.
   2. Slowly pull the strips apart.
   3. Apply a strip to the area to be epilated, pressing with your fingers in the direction of hair growth.
   4. Immediately with one hand, tighten the skin at the base of the strip. With the other hand, lift the end of the strip and pull flush and against the grain. It is important to keep the skin taut and pull the strip as parallel to the skin as possible.Translated with www.DeepL.com/Translator (free version)
3. Una vez depilada, aplica una toallita post-depilación.
   

The skin should be clean and dry before waxing.

1. Hold the strips between your hands for a few seconds.
2. Slowly pull the strips apart.
3. Apply a strip to the area to be waxed, pressing with the palm of your hand in the direction of hair growth.
4. Immediately with one hand, tighten the skin at the base of the strip. With the other hand, lift the end of the strip and pull flush and against the grain. It is important to keep the skin taut and pull the strip as parallel to the skin as possible.
5. You can use the same strip several times until it no longer adheres sufficiently to the hair, then change to a new strip.
6. Once epilated, apply a post-depilation wipe.

Carefully follow the heating and usage instructions on the leaflet included in the product box.
When the temperature of the wax is correct, it will have an ideal thick and creamy honey texture. Application and removal of the wax will then be as easy as that:

1. Take a generous amount of wax with the end of the spatula.
2. Immediately, with the edge of the spatula, slide the wax in the direction of hair growth, forming a very thin strip of wax.
3. Let the strip dry until it no longer sticks to the touch. With one hand, tighten the skin at the base of the strip and with the other hand, lift the end of the wax with your fingertips using Once waxed, apply a post-waxing wipe.

IF THERE IS ANY WAX LEFT OVER IN THE JAR, SAVE THE LEAFLET FOR THE NEXT APPLICATION.